KAR-TECH CAN RANGER - Auxiliary and Boom 2 Setup

CAN RANGER OPERATION
26
Next the Auxiliary setup
screen will appear:
AUX DISABLE
THEN PUSH SET
Use ↑ or ↓ to select between
DISABLE, WINCH FAST, and
TOGGLE functions. These
functions are for the Auxiliary
toggle switch on the
transmitter and the Auxiliary
output on the receiver. If your
machine has the Winch Speed
feature, you want to set this
to WINCH FAST. If you have
some other function tied to
the Auxiliary output, set this
to TOGGLE mode. Otherwise
disable it. If you leave it
enabled but do not have the
feature, you will get an error
indicating that there is an
output error. No damage will
occur.
When you have made your
selection, press <SET>.
Next the TELE 2 setup screen
will appear:
TELE 2 DIS
THEN PUSH SET
Use ↑ or ↓ to toggle between
ENABLE or DISABLE for the
TELESCOPE #2 function
(actuator). If your machine
has a second boom
TELESCOPE feature, you want
to set this to ENABLE (ENB).
Otherwise disable it. NOTE:
You can use TELE 2 for
another actuator controlled
function you might have,
other than the standard
functions. If you enable TELE
2 but do not have the feature
or actuator, you will get an
error indicating that there is
an actuator error. No damage
will occur.
When you have enabled or
disabled the TELE 2 feature,
press <SET>.