CAN RANGER OPERATION
28
TIME, the CAN Actuator will
turn off its clutch and motor.
The corresponding joystick
needs to be centered and
then activated again for the
CAN Actuator to try to move
again.
To set the REACH ERR TIME
the REACH ERR TIME setup
screen will appear:
REACH ERR TIME
xx.xs PUSH SET
Use ← and → to select the
digit and ↑ or ↓ to increase
and decrease the selected
digit. Push SET when you are
done.
The REACH ERR WINDOW
setup screen will appear:
REACH ERR WINDOW
x.xxin PUSH SET
Use ← and → to select the
digit and ↑ or ↓ to increase
and decrease the selected
digit. Push SET when you are
done.
Next the HORN LOGIC setup
screen will appear:
HORN LOGIC ENB
THEN PUSH SET
WARNING: Per ANSI standards,
it is the responsibility of the
operator to press horn to
operate the care. This feature
is factory enabled to make sure
the operator pushes horn
before operating the carne.
Disabling this function will
leave the responsibility solely
on trained care operator.
Use ↑ or ↓ to toggle between
ENABLE or DISABLE for the
HORN LOGIC. When Enabled,
the HORN button needs to be
pushed, along with an ENABLE
button for 1 second before
any joystick functions can be
activated. This needs to be
repeated if no joystick
To Next Page
Loading...
