KBL 4800 alpha - Page 36

Operating Instructions | KBL 4800 alpha
36
⑤
①
②
③
④
⑥
⑤
CLEANING AND DISINFECTION PLAN
Part Application Cleaning and disinfection activities Interval
①
Bench pane & handles
Directly on the
surface
Clean these parts with single-pass paper towels. Use
only EPA registered quaternary ammonium germicidal
based detergent solution (follow product label for use-
dilution), such as Lucasol One Step, to clean and disin-
fect the tanning device and its components.
For thorough cleaning and disinfection, the product
must be allowed to remain in contact with the surface
being cleaned and disinfected for a specified amount
of time. This specified amount of time depends on the
cleaner/ disinfectant which is used. Follow the direc-
tions for use of the cleaner/disinfectant. After this speci-
fied application time remove remaining cleaner/disinfec-
tant from the surfaces of the tanning device.
After each tanning session
②
Control panel
③
Canopy pane
Directly on the
surface
④
Protective goggle and
neck pillow
⑤
Air Filter inserts
- Remove the inserts and rinse out under running water. 100 operating hours
⑥
Condensate canister
-
Empty the condensate canister if a corresponding mes-
sage is displayed at the interior control panel.
When required
Tubes
Remove tubes and clean them with a damp chamois.
200 operating hours
UV filter panes and
facial tanner
Clean them with a damp chamois.
Chromed parts
Clean with a damp chamois and a cleaning agent for
acrylic plastic (antistatic).
When required
Plastic surfaces and
varnished surfaces
Clean with a damp soapy cloth. Never clean with a dry
cloth!