KBL 4800 alpha - Filter Panes

Operating Instructions | KBL 4800 alpha
41
⑧
⑨
⑧
Reach into the rear ventilation gap positioned
in the middle of the pane.
⑨
Carefully pull the pane towards the front and
out of the tanning area.
⇒
Deposit the pane in a safe place.
ASSEMBLY NOTE
Proceed in reverse order in order to re-install the
canopy pane. Make sure that the profil-guide is cor-
rectly positioned.
When closing the canopy pane, make sure that
the profil-guide is correctly positioned.
10.6 Filter panes
4
↵
DANGER
Excessive UV radiation
Operating the tanning device with defective filter
panes can result in serious injury to skin and eyes.
• Never operate the tanning device if the filter pane is
not present or defective.
• Carry out regular visual inspections.
• Replace filter panes only with ones of the same
type.
• Have the filter panes installed only by qualified,
trained and authorized service technicians.
REMOVING THE FILTER PANES (PREPARATION)
⑩
⑪
⑪
⑫
⑫
⇒
Tilt the canopy pane down.
⑩
Undo the screws of the mirror panels (4 x M5).
⑪
Remove the central panels.
⑫
Tilt up the outer panels.