Operating Instructions | KBL 4800 alpha
44
10.9 Facial tanners
4
↵
Reflector
High-pressure lamp
Lamp holder
REPLACING THE HIGH-PRESSURE LAMP
Dirt accumulation and bad seating can
lead to damage during the operation.
• Make sure that tanners and high-pressure
lamps are correctly positioned in their respec-
tive holders. Make sure that the contact sur-
faces are clean when you insert the lamp.
• When installed, the little glass pin in the mid-
dle of the light bulb must point towards the
reflector.
• Never touch the lamp or the reflector with your
bare hands. If necessary, remove grease and
dirt with an alcohol-containing agent.
Attention!
The high-pressure lamps must only be
installed and removed by qualified, trained
and authorized service technicians.
⑰
⑯
⇒
Tilt the canopy pane down.
⇒
Remove the filter panes.
⑯
Hold one end of the high-pressure lamp. Use
a clean cloth free from grease.
⑰
Press the lamp against one side of the holder.
As soon as the relieved side is loose, take the
lamp out of the holder.
To Next Page
Loading...
