KBL 4800 alpha - Acrylic Panes

Operating Instructions | KBL 4800 alpha
39
10.5 Acrylic panes
The acrylic panels used for the tanning devices are
made of acrylic glass especially developed for this
application, featuring a particularly high UV permea-
bility and resistance, as well as an easy-care, hygien-
ic surface that is gentle on the skin.
• The instructions for cleaning and care must be
observed!
• The outer surface can be cleaned without any pre-
paratory works.
The panes are cleaned from the inside
whenever necessary. When cleaning the
inside, it is recommended to clean also
the tubes.
TILTING UP THE BED PANE
↵
④
③
④
④
③
Hold the bed pane in the middle of the front
edge and lift it.
④
Support the bed pane with the two lateral
positioners.
TILTING UP THE INTERMEDIATE PANE
Only for tanning devices with air
conditioning.
⑥
⑤
⑤
Lift the intermediate pane on one side in
order to affix the suction cup in center of the
bed pane.
⑥
The suction cup is attached to the linkage of
the left hand side positioner.
TILTING DOWN THE CANOPY PANE
4
↵
Attention
Prevent the pane from falling down
when opening it.
• Open the middle pane lock at last.