Installation KeContact P20
18 Installation manual, Version: 1.41 / Article no.: 90064
© KEBA 2012-2013
4.1.2 Removing/mounting the connector panel cover
Removing the connector panel cover
Removing the connector panel cover
► Unscrew the four screws with which the
connector panel cover is mounted and
remove the connector panel cover.
Information for reassembly
Connector panel cover removed
Mounting the connector panel cover
► Insert the connector panel cover again.
► Mount the connector panel cover again
using the four screws.
Housing mark
Housing mark
► Tighten the four screws until the mark on
the connector panel cover is even with the
housing surface.
The connector panel cover must seal the
housing properly.
To Next Page
Loading...
