Keba KeContact P20 - 6 Index

KeContact P20 INDEX
Installation manual, Version: 1.41 / Article no.: 90064 47
© KEBA 2012-2013
6 INDEX
A
About this manual ..................................................7
Additional optional equipment.............................11
C
Cable insertion from above - surface cable routing
.........................................................................20
Cable insertion from behind - flush-type cable
routing..............................................................20
Commissioning.....................................................37
Commissioning mode/self test .............................38
Configure the communication with the EV PLC-
>Ethernet (optional).........................................42
Connecting the mains supply line.........................25
Connection overview with opened connector panel
cover.................................................................24
D
Deleting RFID cards.............................................41
Dimensions...........................................................43
DIP-switch settings...............................................33
E
Electrical connection............................................24
Enable input [X1].................................................28
Ethernet1 connection [ETH].................................30
F
Further technical instructions ...............................41
G
General criteria for the site selection....................12
I
Important information ............................................5
Installation............................................................15
Installation guidelines...........................................12
Intended use............................................................7
K
Key switch............................................................10
M
Mounting the charging station..............................21
Mounting the housing cover.................................40
O
Optional equipment..............................................10
Overview................................................................9
P
Preparing the cable insertion................................19
Preparing the housing...........................................17
Product description.................................................8
Programming RFID cards (optional)....................41
Programming RFID user cards.............................41
Programming the RFID master card.....................41
R
Removing the housing cover................................17
Removing/mounting the connector panel cover...18
Replacing the fuse................................................42
RFID sensor .........................................................10
S
Safety checks........................................................39
Safety instructions..................................................5
Space requirements ..............................................14
Specifications for the electrical connection..........13
Standards and regulations.....................................46
Switch contact output [X2]...................................29
T
Technical data ......................................................44
Terminals [X1/X2]...............................................30
Tool list ................................................................16
U
Use of this manual.................................................. 7
V
Validity...................................................................7
Variant overview....................................................9