Keba KeContact P20 - Terminals [X1;X2]; Ethernet1 Connection [ETH] (Optional)

Installation KeContact P20
30 Installation manual, Version: 1.41 / Article no.: 90064
© KEBA 2012-2013
4.4.5 Terminals [X1/X2]
Terminal
Terminals
The terminals for the enable input [X1] and the
switch contact output [X2] are designed as
spring-type terminals.
Terminal data:
- Cross-section (min.-max): 0.08 – 4 mm²
- AWG (min.-max): 28 – 12
- Stripping length: 8 mm
- Flathead screwdriver: 3,0 mm
4.4.6 Ethernet1 connection [ETH] (optional)
!
WARNING!
 Danger from compensation currents on shielding!
Compensation currents flowing through shielding in extended systems can
lead to damage to the interfaces and hazards when working on the data lines.
Any measures (such as connecting to a shared distribution board, expanding a
TN-S network, etc.) should be discussed with the person responsible for build-
ing services.
The Ethernet1 is designed as terminal block in LSA+® technology. A hardwired communica-
tion can be realized using the Ethernet1 connection (e.g. for smart home integration or fleet
solutions).