KeContact P20 Installation
Installation manual, Version: 1.41 / Article no.: 90064 33
© KEBA 2012-2013
4.5 DIP-switch settings
DIP-switches
DIP-switches
The DIP-switches are used for the addressing
and configuring the charging station and are
located under the connector panel cover.
[DSW1]…configuration (upper DIP-switch)
[DSW2]…addressing (lower DIP-switch)
DIP-switch example
The figure shows for a better explanation, the
position of the DIP-switches for the ON and
OFF state.
INPUT/OUTPUT (DSW1) / ONLY FOR STANDARD MODE
Function DIP-switch Figure
External enable input [X1]
is used
D1.1 ON=yes
Switch contact output [X2]
is used
(fan specification)
D1.2 ON=yes
To Next Page
Loading...
