Installation KeContact P20
32 Installation manual, Version: 1.41 / Article no.: 90064
© KEBA 2012-2013
Preparing the connection cable
Preparing the connection cable
► Strip the connection cable approximately
6 cm.
► Fold back approx. 1 cm of shielded
braiding completely and wrap it with
conductive adhesive textile tape.
Connecting the cable
Connecting the cable
► Secure the connection cable at the point
of the wrapped shielded braiding in the
cable clamp [K].
The cable clamp must be screwed onto
the ground point [GND] of the circuit
board.
► Clamp the wires to the terminal block
[ETH] using the insertion tool.
To Next Page
Loading...
