Installation KeContact P20
40 Installation manual, Version: 1.41 / Article no.: 90064
© KEBA 2012-2013
4.6.3 Mounting the housing cover
Fitting the housing cover
Fitting the housing cover
► Fit the housing cover at the top and push
the cover downwards slightly.
Make sure that the housing cover is
seated correctly at the top in the housing
guides.
Mounting the housing cover
Mounting the housing cover
► Then fold the housing cover to the rear.
The housing cover must glide into the
guides without considerable resistance.
► Make sure that the housing cover is
seated correctly on all sides in the
housing guide.
Only a minimum, even gap may be
present.
Cover screws
Cover screws
► Secure the housing cover at the bottom
using the two cover screws [S].
To Next Page
Loading...
