KeContact P20 Installation
Installation manual, Version: 1.41 / Article no.: 90064 23
© KEBA 2012-2013
Schematic diagram
Mounting the charging station
► Turn the hanger bolts into the anchors
until the thread still protrudes
approx. 2 cm ('x').
► Use the shims [A] to compensate for any
unevenness and to ensure a water
drainage behind the device.
► Position and mount the charging station
using the supplied washers and nuts.
[A]…shim
[B]…charging station housing
[C]…washer
[D]…nut
Installation on hollow walls
Installation on hollow walls
For installation on hollow walls, at least two
mounting screws must be secured to a support
element of the wall (see figure).
Special hollow-wall anchors must be used for
the other mounting screws.
When installing on hollow walls you must en-
sure that the bearing strength of the construc-
tion is sufficient.
To Next Page
Loading...
