57
Instructions for use and maintenance of the engine water cooling system
[Cooling System] (Figure 33)
The cooling system can prevent the engine from overheating,
and the correct use and maintenance of the cooling system can
extend the service life of the engine.
The radiator is located in the front of the engine. According to
the road conditions you are driving, the radiator should be
regularly cleaned of dust and dirt.。
[Coolant Type]
Coolant has five characteristics of anti-corrosion, anti-cavitation, high boiling point, anti-scaling and anti-freezing.
The coolant is generally mixed with concentrated antifreeze and soft water (pure water or distilled water) in an appropriate ratio. Please adjust it to
a fixed concentration that is suitable for the local minimum temperature. Generally, when it is adjusted to a concentration of 40% to 50%, the
antifreeze function is the best.
It is recommended that you use the direct coolant specially designed for aluminum alloy engines. This coolant has been prepared in the factory
and contains antifreeze, rust inhibitor, foam inhibitor and trace silicate, etc., and the use is indicated on the container Ambient temperature.
Note:
1. This coolant is a special coolant and cannot be replaced with tap water or other liquids, otherwise it may cause damage to the
engine.
2. Please go to the designated dealership to purchase direct type coolant exclusively for aluminum alloy engines.
3. If the coolant needs to be replaced or coolant leakage occurs, please go to the designated dealership for replacement and
maintenance.
To Next Page
Loading...
Need help?
General
