GETTING STARTED
15
Configuration Settings
Setting Configuration Settings
Background
The normal configuration settings (F-01~F-61,
F-88, F-89) are used to configure or view system
settings. Use the following operation steps
when configuring the interface settings used in
the Remote Control chapter on page 20.
• Ensure the load is not connected.
• Ensure the output is off.
Note
Configuration settings F-90~F-95 cannot be edited
in the Normal Function Settings. See the user
manual for details.
The F-89 settings can only be viewed, not set.
Steps
1. Press the Function key. The
function key will light up.
2. The display will show F-01
on the top and the
configuration setting for
F-01 on the bottom.
3. Rotate the Voltage knob to change
the F setting.
Range
F-00~ F-61, F-88, F-89
To Next Page
Loading...
