Keithley 2260B-30-36 - Configure Ethernet Connection

REMOTE CONTROL
23
Configure Ethernet Connection
The Ethernet interface can be configured for a number of different
applications. Ethernet can be configured for basic remote control or
monitoring using a web server or it can be configured as a socket
server.
The 2260B series supports DHCP connections so the instrument can
be automatically connected to an existing network or alternatively,
network settings can be manually configured.
Ethernet
configuration
Parameters
For details on how to configure the Ethernet
settings, please see the configuration table on
page 16.
MAC Address
(display only)
LAN
DHCP IP Address
Subnet Mask Gateway
DNS Address Sockets Active
Web Server Active Web Password Active
Web set password 0000~9999 (default 0000)
Web Server Configuration
Configuration
This configuration example will configure the
2260B as a web server and use DHCP to
automatically assign an IP address to the 2260B.
1. Connect an Ethernet cable from the
network to the rear panel Ethernet
port.