Keithley 2260B-30-36 - Status Commands; Status:operation:enable

REMOTE CONTROL
51
Status Commands
STATus:OPERation[:EVENt] ........................................... 51
STATus:OPERation:CONDition ...................................... 51
STATus:OPERation:ENABle ............................................ 51
STATus:OPERation:PTRansition ...................................... 52
STATus:OPERation:NTRansition ..................................... 52
STATus:QUEStionable[:EVENt] ...................................... 52
STATus:QUEStionable:CONDition ................................. 53
STATus:QUEStionable:ENABle ....................................... 53
STATus:QUEStionable:PTRansition ................................. 53
STATus:QUEStionable:NTRansition ................................ 53
STATus:PRESet ................................................................... 54
STATus:OPERation[:EVENt]
Description
Queries the Operation Status Event register and
clears the contents of the register.
Syntax STATus:OPERation[:EVENt]?
Return <NR1>
Returns the bit sum of the Operation Status
Event register.
STATus:OPERation:CONDition
Description
Queries the Operation Status register. This query
will not clear the register.
Syntax STATus:OPERation:CONDition?
Return <NR1>
Returns the bit sum of the Operation
Condition register.
STATus:OPERation:ENABle
Description
Sets or queries the bit sum of the Operation Status
Enable register.
Syntax
Query Syntax
STATus:OPERation:ENABle <NRf>
STATus:OPERation:ENABle?
Query
Query
Set
Query