Settings available for resistance measurements
The following DMM attributes are available for resistance measurements:
• aperture (range of 10 µs to 0.250 s for 50 Hz; 8.33 µs to 0.250 s for 60 Hz)
• autodelay (dmm.AUTODELAY_ONCE, dmm.ON or dmm.OFF)
• autorange (dmm.ON or dmm.OFF)
• autozero (dmm.AUTOZERO_ONCE, dmm.ON or dmm.OFF)
• display digits (3, 4, 5, 6, or 7)
• dry circuit (dmm.ON or dmm.OFF) (only for four-wire ohms and commonside ohms)
• filter count (1 to 100)
• filter enable (dmm.ON or dmm.OFF)
• filter type (dmm.FILTER_MOVING_AVG or dmm.FILTER_REPEAT_AVG)
• filter window (0 to 10%)
• DMM limit auto clear (dmm.ON or dmm.OFF)
• DMM limit enable (dmm.ON or dmm.OFF)
• DMM limit high fail (0 or 1)
• DMM limit high value (–4294967295 to +4294967295)
• DMM limit low fail (0 or 1)
• DMM limit low value (–4294967295 to +4294967295)
• line synchronization (dmm.ON or dmm.OFF)
• math enable (dmm.ON or dmm.OFF)
• math format (dmm.MATH_NONE, dmm.MATH_MXB, dmm.MATH_PERCENT, or
dmm.MATH_RECIPROCAL)
• math mxb b factor (–4294967295 to +4294967295)
• math mxb m factor (–4294967295 to +4294967295)
• math mxb units
• math percent (–4294967295 to +4294967295)
• nplc (0.0005 to 15 for 60 Hz; 0.0005 to 12 for 50 Hz)
• offset compensation (dmm.ON or dmm.OFF) (only for four-wire ohms and commonside ohms)
• open detector (dmm.ON or dmm.OFF) (only for four-wire ohms and commonside ohms)
• range (0 to 120e6)
• relative offset enable (dmm.ON or dmm.OFF)
• relative offset level
To Next Page
Loading...
Need help?
General
