Keithley 3720-ST

Series 3700A System Switch/Multimeter Reference Manual Section 9: Introduction to TSP operation
3700AS-901-01 Rev. D/June 2018 9-23
Channel
Channel functions and attributes allow you to adjust, select, open, and close channels. You can also
set common channel attributes and set up channel patterns.
The channel functions and attributes are:
channel.calibration.adjustcount() (on page 11-38)
channel.calibration.adjustdate() (on page 11-38)
channel.calibration.lock() (on page 11-40)
channel.calibration.password() (on page 11-40)
channel.calibration.save() (on page 11-41)
channel.calibration.step() (on page 11-42)
channel.calibration.unlock() (on page 11-44)
channel.calibration.verifydate() (on page 11-45)
channel.clearforbidden() (on page 11-46)
channel.close() (on page 11-46)
channel.connectrule (on page 11-48)
channel.connectsequential (on page 11-50)
channel.createspecifier() (on page 11-51)
channel.exclusiveclose() (on page 11-52)
channel.exclusiveslotclose() (on page 11-54)
channel.getbackplane() (on page 11-55)
channel.getclose() (on page 11-58)
channel.getcount() (on page 11-59)
channel.getdelay() (on page 11-61)
channel.getforbidden() (on page 11-62)
channel.getimage() (on page 11-63)
channel.getlabel() (on page 11-64)
channel.getmatch() (on page 11-65)
channel.getmatchtype() (on page 11-66)
channel.getmode() (on page 11-67)
channel.getoutputenable() (on page 11-69)
channel.getpole() (on page 11-70)
channel.getpowerstate() (on page 11-71)
channel.getstate() (on page 11-72)
channel.getstatelatch() (on page 11-74)
channel.gettype() (on page 11-75)
channel.open() (on page 11-76)
channel.pattern.catalog() (on page 11-77)
channel.pattern.delete() (on page 11-78)
channel.pattern.getimage() (on page 11-78)
channel.pattern.setimage() (on page 11-79)
channel.pattern.snapshot() (on page 11-82)
channel.read() (on page 11-83)
channel.reset() (on page 11-84)
channel.resetstatelatch() (on page 11-86)
channel.setbackplane() (on page 11-87)
channel.setdelay() (on page 11-89)
channel.setforbidden() (on page 11-90)
channel.setlabel() (on page 11-91)
channel.setmatch() (on page 11-92)
channel.setmatchtype() (on page 11-93)
channel.setmode() (on page 11-94)
channel.setoutputenable() (on page 11-95)
channel.setpole() (on page 11-96)
channel.setpowerstate() (on page 11-99)
channel.setstatelatch() (on page 11-100)
channel.trigger[N].clear() (on page 11-101)
channel.trigger[N].EVENT_ID (on page 11-101)