Keithley 3720-ST

Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual
11-324 3700AS-901-01 Rev. D/June 2018
scan.reset()
This function resets the trigger model and scan list settings to their factory default settings.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
scan.reset()
Details
When scan.reset() is sent, the trigger model and scan settings that are reset to the factory
defaults are:
▪ scan.bypass
▪ scan.measurecount
▪ scan.mode
▪ scan.scancount
▪ scan.trigger.arm.stimulus
▪ scan.trigger.channel.stimulus
▪ scan.trigger.measure.stimulus
▪ scan.trigger.sequence.stimulus
In addition, the scan list is cleared.
Sending this function only affects the trigger model and scan list settings. To reset all instrument
settings to factory default settings, use the reset() command.
Example
scan.reset()
Performs a reset on the trigger model and
scan settings.
Also see
channel.reset() (on page 11-84)
dmm.reset() (on page 11-219)
reset() (on page 11-308)
scan.bypass (on page 11-314)
scan.measurecount (on page 11-320)
scan.mode (on page 11-321)
scan.scancount (on page 11-325)
scan.trigger.arm.stimulus (on page 11-328)
scan.trigger.channel.stimulus (on page 11-331)
scan.trigger.measure.stimulus (on page 11-334)
scan.trigger.sequence.stimulus (on page 11-336)
Scanning and triggering (on page 5-23)