Keithley 3720-ST

Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual
11-268 3700AS-901-01 Rev. D/June 2018
lan.status.duplex
This attribute contains the duplex mode presently in use by the LAN interface.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
duplex = lan.status.duplex
duplex
LAN duplex setting can be one of the following values:
▪ 0 or lan.HALF: half-duplex operation
▪ 1 or lan.FULL: full-duplex operation
Example
print(lan.status.duplex)
Outputs the present LAN duplex mode, such as:
1.00000e+00
Also see
None
lan.status.gateway
This attribute contains the gateway address presently in use by the LAN interface.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
gatewayAddress = lan.status.gateway
gatewayAddress
LAN gateway address presently being used
Details
The value of gatewayAddress is a string that indicates the IP address of the gateway in dotted
decimal notation.
Example
print(lan.status.gateway)
Outputs the gateway address, such as:
192.168.0.1
Also see
lan.config.gateway (on page 11-262)