3-6 Test Script Processor Interaction Series 2600 System SourceMeters User’s Manual
2600S-900-01 Rev. A / May 2006 Return to In this section:
Modifying a factory script
Reference Refer to “Factory scripts” in Section 2 of the Series 2600 Reference
Manual for more information on modifying a factory script.
A factory script can be imported from the Series 2600 into the Test Script Builder
where it can be modified. The modified script can then be loaded back into the
Series 2600 and saved as a user script.
The following procedure will import the KIGeneral factory script into the Test
Script Builder, modify code for the SourceVMeasureI function, load the script in
the Series 2600 as a user script under a different name, and then configure the
test to call the SourceVMeasureI function.
Step 1: Importing a factory script project
A factory script project is made of many executable functions. The
SourceVMeasureI function is one of the functions that make up the KIGeneral
factory script that is stored in the Series 2600.
Figure 3-2 shows how to import the KIGeneral factory script project from the
Series 2600 into the Test Script Builder. After importing the script, the project will
appear as a folder in the Project Navigator with a script file named “main.tst”
(Refer to
Figure 3-3).
To Next Page
Loading...
Need help?
General
