Kemppi Kempact Pulse 3000 Operation Instructions

20 – Kempact pulse 3000, Kempactcool 10 / 0813 © Kemppi oy
4. MAINTENANCE
4.1. DAILY MAINTENANCE
Be careful of mains voltage when handling electric cables!
Clean the wire channel of the gun and check the contact tip regularly. Always check the condition
of the mains and welding cable before operation and replace defective cables.
Note! Only a qualied electrician should remove or install the mains cable!
4.2. REGULAR MAINTENANCE
KEMPPI -service workshops sign special service contracts with customers for regular maintenance.
All parts are cleaned, checked and if necessary, repaired. The operation of the welding machine
is also tested.
4.3. DISPOSAL OF THE MACHINE
Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and returned to an
environmentally compatible recycling facility. As the owner of the equipment, you should
get information on approved collection systems from our local representative.
By applying this European Directive you will improve the environment and human
health!
5. ORDERING INFORMATION
Item Ordering number
Kempact Pulse 3000 621830002
KempactCool 10 621860001
GH 30 Gun holder 6256030
PMT 25 3 m 6252513
PMT 25 4,5 m 6252514
PMT 27 3 m 6252713
PMT 27 4,5 m 6252714
PMT 32 3 m 6253213
PMT 32 4,5 m 6253214
PMT 30W 6253043
PMT 30W 6253044
PMT 35 3 m 6253513
PMT 35 4,5 m 6253514
WS 35 6 m Al1,2 6253516A12
WS 35 6 m Ss1,0 6253516S10
WS 30W 6 m Al 1,2 6254206A12
WS 30W 6 m Ss 1,0 6254206S10

Kemppi Kempact Pulse 3000 Specifications

General

Brand	Kemppi
Model	Kempact Pulse 3000
Category	Welding System
Language	English