Wire feed motor current measuring
By pressing the Wire Inch-button and plate thickness-button simultaneously the motor M001
current will be seen on the right side of the display.
Wire feed motor current
21
Panel layout
X10 X11 X1
X1 Flat cable panel >
power source
X10 Programming
connector, panel
X11 Programming
connector, power
source
Panel switches, LEDs and displays can be tested. After turning the power source on (3 sec.) all LEDs
and displays should be lighted and after pressing any of the buttons the program versions should be
shown on the panel.
Panel program version
Power source program version
Panel testing
To Next Page
Loading...
Need help?
General
