(_ Mark for placement of buttonhole
@ Starting point
(_ Slider
(_ There should be no gap,
0 Spring holder
(_ Difference
[] Draw both threads to the left under the foot.
Insert the garment under the foot, and lower the needle
into the fabric to the starting point,
Then lower the automatic buttonhole foot.
Sew slowly and stop the machine at the starting point
when the buttonhole is completed,
\
[] Remove the fabric and place a pin just before the fr_
barrack at each end, to prevent cutting bartacks. Cut the
L2J
opening with the buttonhole opener.
[] To sew another buttonhole, you must reset the machine,
Reset by shifting the stitch selector in either direction,
(_)or O, to the next setting, Then shift the selector back
to the buttonhole setting 'I]"
[] When finished, push the buttonhole lever up as far as it
will go.
\
f
[]
I
J
J
J
76
To Next Page
Loading...
