ES749 Flow Computer
38
SYSTEM PARAMETERS
6.4
SYSTEM
PARAMETERS
(Continued)
A personalized tag can be entered for unit I.D. purposes.
Note:
• Maximum of 10 characters.
• Spaces are considered characters and must be conrmed
by pressing the ENTER key.
Input:
Alphanumeric characters for each of 10 positions
1...9; A...Z;_, <, =, >, ?, etc.
Flashing selections can be changed.
Store and Conrm entries with the ENTER key.
Display: FT101
TAG NUMBER
TAG NUMBER
ENGINEERING CODE
Note:
The Engineering Code will
allow access to the same
information as the Private
Code with the following ad-
ditional functions:
• Change the Service Code
• Change the Order Code
• Change the Serial No.
• Clear Grand Total
• Clear Errors in Error Log
• View & Perform calibra-
tion in Service & Analysis
Menu
• Restore Factory Calibra-
tion Information in Service
& Analysis Menu
• Set Next Calibration Date
• Print Maint.Report
• Perform Service Test
A personal enginerring code may be dened. This code is used to
enable program menus that are normally reserved for engineering
personnel.
(i.e.: Service & Analysis Submenu Group)
Note:
• The engineering code is factory set to 3000
• The engineering code submenu will only appear if the
engineering code was entered for the "Access Code".
Input:
Maximum 4 digit number: 0...9999
Store and Conrm entries with the ENTER key
Display: 3000
SERVICE CODE
To Next Page
Loading...