KEP ES749 - Page 48

ES749 Flow Computer
44
SYSTEM UNITS
Select the unit of corrected volumetric owrate
(corrected volume/time base).
Note:
The unit selected here also applies to the following:
• Zero and full scale value for current
• Relay setpoints
Corrected Volume = volume measured under operating conditions
converted to volume under reference conditions.
Selection:
The available selections will change depending on the ow equation
selected.
bbl/time base, gal/time base, l/time base, hl/time base, dm
3
/
time base, ft
3
/time base, m
3
/time base, scf/time base, Nm
3
/
time base, NI/time base, igal/time base, mcf/time base
All units listed above apply to corrected volume.
Display: scf/h
COR.VOL. FLOW UNIT
Select the unit of volume for the particular totalizer.
Note:
The unit selected here also applies to the following:
• Pulse value for pulse output
• Relay setpoints
Corrected Volume = volume measured under operating conditions
converted to volume under reference conditions.
Selection:
The available selections will change depending on the ow equation
selected.
bbl, gal, l, hl, dm
3
, ft
3
, m
3
, scf, Nm
3
, NI, igal, mcf
All units listed above apply to corrected volume.
Display: scf
COR.VOLUME TOT.UNIT
COR.VOL.
FLOW UNIT
COR. VOLUME TOT.
UNIT
6.6
SYSTEM
UNITS
(Continued)