KERN 440 Series User Manual

440-BA-e-1744
16
 Weigh the material, the net weight will be indicated.
The taring process can be repeated any number of times,
e.g. when adding several components for a mixture
(adding). The limit is reached when the whole weighing
range is exhausted.
The weight of the weighing container will be displayed as a
minus number after removing the weighing container.
The tare weight is saved until it is deleted.
Delete tare
 Unload the balance and press the TARE button, the zero
display appears.
PRE-TARE-
Function
Using this function the weight of a tare vessel is stored. Even
after turning off/on the weighing balance will continue working
with the saved tare value.
 In weighing mode put tare vessel on the weighing plate
 Press repeatedly the MODE key until „PtArE“ flashing
appears.
 Use SET key to store the current weight on the weighing
plate as a PRE-TARE value.
Delete PRE-TARE
value
 Remove all loads from the balance and press repeatedly the
MODE key until „PtArE“ flashing appears.
 Use the SET key to confirm. The PRE-TARE value is
deleted, the zero display appears.
TA R E
MODE
CAL
MODE
CAL

KERN 440 Series Specifications

General

Weighing plate material	stainless steel
Readability	0.01g
Calibration	External
Display	LCD
Reproducibility	0.01 g - 1 g
Minimum part weight at piece counting (Laboratory scale)	0.01g
Minimum part weight at piece counting (Precision scale)	0.01g
Power supply/adapter included	included
Weighing units	g, kg, oz, lb
Interface	RS232
Units	g, kg, oz, lb
Stabilisation time under laboratory conditions	2 seconds