KERN 440 Series User Manual

440-BA-e-1744
36
12 Instant help
In case of an error in the program process, briefly turn off the balance and disconnect
from power supply. The weighing process must then be restarted from the beginning.
Help:
Fault Possible cause
The displayed weight does not glow.
• The balance is not switched on.
• The mains supply connection has been
interrupted (mains cable not plugged
in/faulty).
• Power supply interrupted.
• Batteries are inserted incorrectly or empty
• No batteries inserted.
The displayed weight is permanently
changing
• Draught/air movement
• Table/floor vibrations
• The weighing plate is in contact with
foreign matter.
• Electromagnetic fields / static charging
(choose different location/switch off
interfering device if possible)
The weighing value is obviously
wrong
• The display of the balance is not at zero
• Adjustment is no longer correct.
• Great fluctuations in temperature.
• Electromagnetic fields / static charging
(choose different location/switch off
interfering device if possible)
Should other error messages occur, switch balance off and then on again. If the error
message remains inform manufacturer.

KERN 440 Series Specifications

General

Weighing plate material	stainless steel
Readability	0.01g
Calibration	External
Display	LCD
Reproducibility	0.01 g - 1 g
Minimum part weight at piece counting (Laboratory scale)	0.01g
Minimum part weight at piece counting (Precision scale)	0.01g
Power supply/adapter included	included
Weighing units	g, kg, oz, lb
Interface	RS232
Units	g, kg, oz, lb
Stabilisation time under laboratory conditions	2 seconds