KERN EFC 30K-3 - Page 24

24 TEFC_A-BA-e-2110
Setting conditions of sending and limits:
1. In the weighing mode, press and hold the TOL, < > will be displayed.
2. Using the TARE button, select the required signaling condition.
You can choose:
1.
If the weighed portion is in the present limit range, a sound is heard and a
LED at the [ ] is green.
2.
If the weighed portion is below the lower limit value, the sound is not
heard and the LED at the [–] symbol is yellow.
3.
If the weighed portion is above the upper limit value, the sound is not
heard and the LED at the [
+
] symbol is red.
1. If the weighed portion is in the present limit range, a sound is not heard
and the LED at the [ ] is green.
2.
If the weighed portion is below the lower limit value, the sound is heard
and the LED at the [–] symbol is yellow.
3. If the weighed portion is above t
he upper limit value, the sound is heard
and the LED at the [
+
] symbol is red.
1.
If the weighed portion is above the upper limit value, the sound is heard
and the LED at the [+] symbol is red.
2. If the weighed portion is below the upper limit value, the sou
nd is not
heard and the LED at the [
–
] symbol is yellow.
1. If the weighed portion is below the lower limit value, the sound is heard
and the LED at the [–] symbol is yellow.
2.
If the weighed portion is above the lower limit value, the sound is not
heard and the LED at the [
+
] symbol is red.
3. Confirm the selection by pressing M , < > will be displayed for a while.
The window for value entry in the numerical form will be displayed where you can
enter the lower limit value < >. Red LED under the active place will be
lit.
4. Enter the lower limit value (for entering the numerical value see chapter 3.2.1)
and confirm.
5. < > will be displayed for a while. The window for value entry in the numeri-
cal form will be displayed where you can enter the upper limit value. Red LED
under the active place will be lit.
6. Enter the upper limit value (for entering the numerical value see chapter 3.2.1)
and confirm.
7. < > will be displayed for a while, the scale will switch to the weighing mode
again.