KN-4006 series UV Radiation Treatment System
less than 0.1Ω, cut area should not be less than 2.5mm
2
, the length
should be more than 3.5m.
NOTICE:
—— before connecting the power supply, make sure the
supplied voltage is the same as the equipment
requirement.
—— Equipment must be inserted to a power outlet which is
used for it only, can not be shared with other equipments.
It is better to apply regulated power supply in unstable
power voltage.
—— Do not place equipment in vibration, shaking place
—— Ensure suitable working condition when the equipment
is running.
To Next Page
