KN-4006 series UV Radiation Treatment System
key, ”beep” sound will be heart before working, then the count
down time starts. At the last 10 seconds will have a warning
sound。
Ø pause treatment
press“START/STOP” to pause treatment，lamp puts out，
countdown pause，press“START/STOP”key to recover the
treatment process，lamp lighten，continue the count down time。
Ø stop treatment
count down time is finished, the lamp will be close
automatically. and finish the treatment.
setup the save function
On the condition of stopping, if you need to check the time
that you setup last treatment, press “START/STOP”
key ， ”Irradiation time” shows last setup time. press again
“START/STOP”key，device starts to work.
Close it and start it again, the last setup treatment time. will
be shown.
NOTE: Shall confirm the preset treatment time is correct and
treatment, such as incorrect should be reset.
To Next Page
