KN-4006 series UV Radiation Treatment System
l Prohibit to put it in anesthetic inflammable and explosive
environment, in case of fire or explosion.
l Prohibit to open the Instrument shell without
authorization, or may have get an electric shock risk. To
Instrument maintenance or upgrade must be after the
company training or authorized service personnel.
l If supply voltage fluctuation is too large, it should be with
an accuracy of 2% of the AC regulator;
l In order to prevent electrical shock occurrence and
reduce equipment failure, equipment can not be watered.
If there is a water inflow by accident, please stop using it
immediately. The equipment should be overhauled by
professional and technician before reuse.
l Before it was put to use instrument should be carefully
observed power cable, power switch and the safety of
tubes, damaged cable, switch, tube should be replaced
immediately. The operator can't also contact patients with
more damaged parts, so as to avoid the danger.
l For the equipment with time controller, operator must
confirm the correct time first, then power on the lamp.
l Treatment dose should be adjusted depending on the
degree of the reaction of the patients by the attending
physician.
l Don't treat more than once a day.
l During treatment, please do not have sunbathing.
l If lamps breakage, please timely recycling, avoid debris
To Next Page
