PIR Motion Detector
The motion detector is designed for use on interior walls and is set to
‘Out Arm Active’ Mode by default. Whenever the sensor detects
movement (only while the alarm is armed), a push notification including
the sensor name will automatically be sent to the registered users,and
the alarm will sound .
Detection window
LED Indicator
Blinks for 30 seconds after detector
powers up. Lights up when there’s
motion in the room. And blinks in
case of low battery, please replace
the battery soon.
Zone setting
Bracket
Power ON/OFF
Slide it to ‘ON’ to power up the detector.
LED on/off jumper
ON enables the LED on.
To save battery power in normal use,
if the detector is triggered twice within 3
minutes, it enters sleeping state
immediately. During this period,
movement detected does not
generate an alarm. After no
any
within the next 3 minutes, it goes back to
working state again.
movement
For effective walk
testing, set ON as shown to the right.
When walk testing done, set OFF to
save power as shown to the right .
Working mode jumper
Battery receptacle
Includes two AAA 1.5V battery.
13
To Next Page
Loading...
