Magnet Quantity Settings
n represents magnet numbers of PAS disk. The default value is 6.
Press the UP/DOWN button to choose quantity for changing magnet numbers of PAS disk,
Hold i button for 2s to confirm and then return to previous menu.
PAS magnet disks settings
◆Speed sensor settings (optional)
SPS represents speed sensor settings. The default value is 1
Press the UP/DOWN button to choose the quantity of magnet heads (the range is from 1 to 15).
Hold i button for 2s to confirm and then return to previous menu.
Speed sensor magnet heads settings
◆
Throttle functions (optional)
Throttle push assist enable/disable
HL represents throttle push-assist function. HL-N means throttle assist push function is disabled. HL-y means
throttle assist push function is enabled. The default value is N. Press UP or DOWN button to select Y or N to set
throttles push-assist functions. Hold i button for 2s to confirm and then return to previous menu. Otherwise, to
select N and then access Throttle Level Enable/Disable Setting
Throttle push assist enable/disable
To Next Page
Loading...
