Push-assist button enable/disable settings
PUS means push-assist button enable/disable settings. Press UP/DOWN button to choose Y or N. Y is enable
while N is disable. Press i to confirm. The default value is Y.
Push-assist button enable/disable
Slow Start up Settings
SSP represents slow start up. The range is “1-4”, “4” is the slowest. The default value is “1”.
To change slow start up settings, press the UP/DOWN button to choose the desired value.
Press i button and moves to Delay time settings for battery power.
Alternatively, hold i button for 2s to return to previous menu.
Slow start up settings interface
◆Power-on password settings
After accessing power-on password settings interface, “P2, 0000” is shown on the screen and it refers to
power-on password. Power-on password is a 4-digit code. The default password is “1212”. Press UP/DOWN
button to increase or decrease the values and enter the password by pressing i button to confirm digits one by one
and then you can access power-on password Enable Settings. Otherwise stay still in password input state.
To Next Page
Loading...
