Key-Disp KD78C - Power Assist Sensor Setup; PAS Direction Configuration; PAS Sensitivity Adjustment

10
Current settings interface
◆
Power assist sensor settings
PAS represents power assist sensor settings.
PAS direction settings
“run-F” means “go forward” while “run-b” means “go backward”. The default value is “run-F”.
Press the +/- button to select F or b to change the direction of Power Assist Sensor.
To store a changed setting, press i button to confirm and access PAS sensitivity settings
PAS direction settings
PAS Sensitivity Settings
SCN represents PAS sensitivity settings. The sensitivity value ranges from “2” to “9”. “2” is the strongest, “9” is
the weakest. The default value is “2”.
To change the PAS sensitivity, press the +/- button to choose the desired sensitivity value.
To store a changed setting, press i button to confirm and access magnet disk settings.
PAS sensitivity settings