Slowly start up interface
◆Password settings
Press i button to enter the password set. P2 is shown on the screen. Press +/- to increase or decrease the
values and press i to move to the next digit. After 4 digits were entered, press i to confirm. If password is correct,
then enter to the password enable set interface. Or else, it keeps in password input state.
password input and set interface
Password enable
Press +/- to choose Y or N. Y means password is needed while N means password is not needed. Press i
button to confirm. If Y is chosen, press i button to enter password change state. Or else, it will exit password set
interface and return to the display setting items interface.
To Next Page
Loading...
