Keyscan CA8WL-AL - CA8 WL-AL Specifications

Keyscan Inc. A Member of the Kaba Group – CA8WL-AL Rev. B Installation Guide (07.15)
50
CA8WL-AL Specifications
The CA8WL-AL is designed as a single, stand-alone control unit; it does not support CIM, CB-485 or CPB-10-2
connections to other control units. The CA8WL-AL does not support global functions. The table below outlines
CA8WL-AL specifications.
Table 9 - CA8WL-ALB Specifications
Specification
Measurements/Standards
Dimensions
W - 6.875 “ (17.46 cm) x H – 7.625 “ (19.37 cm) x D – 1.75 “ (4.45 cm)
Housing
22 GA steel, black powder coat
Environmental
Operating Temperature: 32
0
F to 120
0
F (0
0
C to 49
0
C)
Humidity: 0 % to 90 % R.H, non-condensing
Power Inputs
PoE (Class 0)
+12V DC independent power supply
CA8WL-AL Current
170 mA to maximum 200 mA
Communication
Ethernet (TCP/IP)
RS-232
PoE
IEEE 802.3af
Class 0
Software Requirements
Aurora – 1.0.8.0 or higher
NETCOM Program Utility – version 6.0.18 or higher for programming on-board
Ethernet module for network communication
Cable
RS-232 – 5 conductor 22 AWG shielded cable - maximum 20 ft (6m)
PoE – CAT 5 or CAT 6 – maximum 328 ft (100 m)
RS485 – CAT 5 – 1 twisted pair – maximum 4000 ft. (1219 m)
Applications
Indoor installations only