8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide 215
Measurement Operations & Settings 4
parameters: 0 or DISabled:
1 or DEFault:
2 or PASSthrough:
3 or LOOPback:
Trigger connectors are disabled.
The Input Trigger Connector is activated, the incoming trigger response for each slot
:TRIGger[n][:CHANnel[m]]:INPut on page 210 determines how each slot responds
to an incoming trigger, all slot events (see :TRIGger[n][:CHANnel[m]]:OUTPut on
page 213) can trigger the Output Trigger Connector.
The same as DEFault but a trigger at the Input Trigger Connector generates a trigger at the
Output Trigger Connector automatically.
The same as DEFault but a trigger at the Output Trigger Connector generates a trigger at the
Input Trigger Connector automatically.
response: none
example: trig:conf dis
command: :TRIGger:CONF?
syntax: :TRIGger:CONF?
description: Returns the hardware trigger configuration.
parameters: none
response: DIS:
DEF:
PASS:
LOOP:
CUSTOM:
Trigger connectors are disabled.
The Input Trigger Connector is activated, the incoming trigger response for each slot
:TRIGger[n][:CHANnel[m]]:INPut on page 210 determines how each slot responds to an
incoming trigger, all slot events (see :TRIGger[n][:CHANnel[m]]:OUTPut on page 213) can
trigger the Output Trigger Connector.
The same as DEFault but a trigger at the Input Trigger Connector generates a trigger at the Output Trigger
Connector automatically.
The same as DEFault but a trigger at the Output Trigger Connector generates a trigger at the Input Trigger
Connector automatically.
A custom configuration is active using either the command :TRIGger:CONF:EXTended on
page 217 or the Keysight 816x VXIplug&play Instrument Driver.
example: trig:conf? -> DEF<END>
command: :TRIGger:CONF:FPEDal
syntax: :TRIGger:CONF:FPEDal<wsp>OFF|ON|0|1
description: Enables or disables the Input Trigger connector to be triggered using a Foot Pedal.
To Next Page
Loading...
