3 Remote Interface Reference
106 Keysight E364xA User’s and Service Guide
Using the APPLy Command
The APPLy command provides the most straightforward method to program the
power supply over the remote interface. You can select the output voltage and
current in one command.
APPLy {<voltage>| DEF|MIN|MAX}[,{<current>| DEF|MIN|MAX}]
This command is combination of VOLTage and CURRent commands.
The APPLy command changes the power supply’s output to the newly
programmed values only if the programmed values are valid within the
presently selected range. An execution error will occur if the programmed
values are not valid within the selected range.
You can substitute “MINimum”, “MAXimum”, or “DEFault’’ in place of a specific
value for the voltage and current parameters. For more details on the
parameters, refer to Table 3-1 for each model
If you specify only one parameter of the APPLy
command, the power supply
regards it as voltage setting value.
APPLy?
This command queries the power supply’s present voltage and current setting
values and returns a quoted string. The voltage and current are returned in
sequence as shown in the sample string below (the quotation marks are
returned as part of the string).
“8.00000, 3.00000”
E3640A model
To Next Page
Loading...
Need help?
General
