12 Installation Note N5222-90131
Description of the Upgrade
Items Included in the Upgrade Kit
-
--
Machine screw, M2.5 x 20, pan head (to attach A26 and A27 receiver coupler
assemblies to test set deck)
6 0515-0430
-- Machine screw, M3.0 x 14, pan head (to install A70 low band board) 4 0515-0665
-- Machine screw, M3.0 x 18, pan head 2 0515-0666
-- Machine screw, M3 x 6, pan head (to attach bias T combiners to brackets) 6 0515-1227
--
Machine screw, M3.0 x 20, pan head (to attach brackets to receiver couplers; to
attach A24 mixer brick to block)
7 0515-1410
-- Machine screw, M3.0 x 6, flat head (to attach dress panel to coupler plate) 2 0515-1946
-- Machine screw, M2.5 x 14, pan head 2 0515-2141
--
Machine screw, M3.0 x 14, pan head (to attach splitter to mixer brick (2) and to
attach bias tees to bracket)
2 0515-2994
-- Cap – coaxial (SMA) 1 0960-0055
-- Bulkhead connector for test set front plate (hardware supplied with connector) 12 1250-3805
-- Nuts – flanged 2 5022-1087
-- Clamp – SMP (port 3 and port 4 bias combiners) 2 5023-3299
-- Cable, assembly, coaxial A06/A06, 205 mm long (Connect to A70 LFE board) 2 8120-5017
-- Cable assembly, flat ribbon 2 8120-0982
-- Gel pad (between each test coupler and the test set front plate) 4 E4403-20033
-- Subpanel, test set – 4-port 1 N5221-00007
-- Dress panel, lower – 4-port 1 N5240-00009
-- Vibration mount (between couplers 1 & 3, and 2 & 4) 2 0460-2725
-- Cable guard, center jumper cables 1 N5242-00049
-- Cable clamp 6 1400-1334
-- Cable clamp (12.9 mm wide) 4 1400-1391
-- Dust caps for test ports 4 1401-0214
-- Bracket for receiver coupler 2 N5242-00006
-- Bracket for attenuator 2 N5242-00007
W2 RF cable, A11 13.5 GHz (SRC 2) direct digital synthesizer (J6)-SRC 2 RF IN P1– (This
cable replaces W2 N5222-20090)
1 N5240-20123
W5 RF cable, A8 source (2) board P5 to W6 on bottom of analyzer – Top Cable 1 N5222-20062
Table 2 Contents of Upgrade Kit N5222-60131
Ref
Desig.
Description Qty Part Number
To Next Page
Loading...
Need help?
General
