Keysight E5052B Signal Source Analyzer 23
Installation
Starting the E5052B
Starting the E5052B
This section describes how to turn on/off the E5052B power and how to cut off
the power supply in an emergency.
Turning the Power ON and OFF
Perform the following steps to turn the power ON or OFF.
To Check the Removable Hard Disk Drive
Procedure
When the power is turned on, it is required to confirm the notch geometry is
set as follows.
Figure 2-5 Removable Hard Disk Drive
Turning the Power ON
Step 1. Confirm if the Line Switch on the rear panel is on. The switch should always
be turned on.
Step 2. If the standby switch ( ) in the lower-left part of the front panel is in the
depressed ( ) position, press it to put it in the popped up position ( ).
Step 3. Press the standby switch to put it in the depressed position ( ).
This operation turns ON the power, and the E5052B starts the self-test.
Step 4. Confirm that the self-test indicates normal operation.
Normal operation is confirmed by the self-test if no error message appears.
If the notch geometry is not set as follows, the error message “OS not
found” will be shown when you turn on the power.
e5071cse3008
To Next Page
Loading...
