Keysight E5052B - DC Power Voltage Test

Keysight E5052B Signal Source Analyzer 25
Installation
Removing / Mounting Removable Hard Disk
Disconnection from Supply Source
The power supply of the E5052B is cut off by disconnecting the plug of the
power cable (on either AC outlet side or E5052B side). When it is necessary to
disconnect the power supply in order to avoid shock hazards, etc., pull out the
power cable plug from either the AC outlet side or the E5052B side.
Removing / Mounting Removable Hard Disk
For details of removing / mounting removable hard disk, refer to the following
website http://ena.support.keysight.com/e5052b/manuals/webhelp/eng/
To allow this operation to be performed smoothly, be sure to follow the
guidelines in “Ensuring Adequate Free Space around Analyzer for
Immediate Disconnection of Power Cable in Case of Emergency” on
page 15.
When turning the power OFF under normal circumstances, always follow
the methods described in “Turning the Power OFF” on page 24.