18 Keysight S5040A Open RAN Studio Player and Capture Appliance User’s Guide
1 Setting up the S5040A Appliance
Perform the following steps prior to powering on the S5040A Appliance:
i Plug a mouse and keyboard into the USB host ports. Four host ports
are on the rear panel, with two more on the front panel.
ii Connect an HD monitor to either the VGA connector or the DisplayPort
+ USB 3 Device Port, depending on the type of connector you have. While
you may connect up to two displays simultaneously, it is recommended
that you connect a monitor to the VGA connector only, when starting up.
iii If you want to connect to a Local Area Network, connect your LAN
cable to the RJ-45 connector on the side panel. Connect the other end to
an open LAN port.
To Next Page
Loading...