Keysight S5040A - Connecting Accessories and LAN Cable

Keysight S5040A Open RAN Studio Player and Capture Appliance User’s Guide 17
Setting up the S5040A Appliance 1
Connecting accessories and LAN cable to the S5040A Appliance
Figure 2 shows the rear panel of the S5040A Appliance.
Figure 2 Rear panel of the S5040A Appliance
The ports on the rear panel of the S5040A Appliance are listed in the order
shown in the image above:
Table 5 Description of the Rear panel connectors
Label# Connector Description
1 Power AC Power input
2 Display Out Type: VGA
3 USB USB 3.0 device port (1x)
4 Display Out Type: DisplayPort
5 USB USB 3.0 host ports (4x)
6 LAN 2x RJ-45 connector, supports 10/100/1000Base-T.
Supports Web-enabled remote control, data/file transfers
and network printing.
7 Audio Microphone, line in, line out
NOTE
Maximum length of the accessory cable should be less than 3 meters to
reduce any RFI interference.