Keysight S5040A - Powering On the S5040 A Appliance

To Next Page

To Previous Page

20 Keysight S5040A Open RAN Studio Player and Capture Appliance User’s Guide

1 Setting up the S5040A Appliance

Powering On the S5040A Appliance

Figure 3 shows the front panel of the S5040A Appliance.

Figure 3 Powering on the S5040A Appliance

Press the power switch in the lower left corner of the S5040A Appliance’s

front panel. The power button turns green in color. After a short

initialization period, the boot up sequence for Windows operating system

appears on the connected display. The S5040A Appliance is ready to use.

You can connect and disconnect SFP / QSFP adapters and modules even

after the Appliance has been powered on.

Powering Off the

Oscilloscope

To power off the S5040A Appliance, do one of the following. The Appliance

will go through a normal Windows operating system shutdown process.

• On the monitor display, click Power > Shut down from the Start menu.

• Press and ‘release’ the power switch at the lower left corner of the

S5040A Appliance's front panel.