Features of your vehicle
1064
The high beam switches to low beam
in the below conditions.
• When High Beam Assist is off.
• When the light switch is not in the
AUTO position.
• When the headlamp is detected
from the on-coming vehicle.
• When the tail lamp is detected
from the front vehicle.
• When the surrounding is bright
enough high beams are not need-
ed.
• When streetlights or other lights
are detected.
• When vehicle speed is below 35
km/h (22 mph).
• When headlamp / taillamp of bicy-
cle/motorcycle is detected.
Turn signals and lane change
signals
The ignition switch must be on for the
turn signals to function. To turn on
the turn signals, move the lever up or
down (A). The green arrow indicators
on the instrument panel indicate
which turn signal is operating.
They will self-cancel after a turn is
completed. If the indicator continues
to flash after a turn, manually return
the lever to the OFF position.
To signal a lane change, move the
turn signal lever slightly and hold it in
position (B). The lever will return to
the OFF position when released.
If an indicator stays on and does not
flash or if it flashes abnormally, one of
the turn signal bulbs may be burned
out and will require replacement.
OSC040420N
OSC047406N
■ Type A
■ Type B
To Next Page
Loading...
