Driving your vehicle
165
(Continued)
• When the stop lamp fuse is blown,
you cannot start the engine nor-
mally.
Replace the fuse with a new one. If
it is not possible, you can start the
engine by pressing the ENGINE
START/STOP button for 10 sec-
onds while it is in the ACC posi-
tion. The engine can start without
depressing the brake pedal. But
for your safety, always depress the
brake pedal and clutch pedal
before starting the engine.
Stopping the engine
(Manual Transmission)
1. Make sure the vehicle is complete-
ly stopped and keep the clutch
pedal and brake pedal depressed.
2. Shift the transmission into Neutral
while depressing the clutch pedal
and brake pedal.
3. Engage the parking brake while
depressing the brake pedal.
4. Turn the ignition key to the LOCK
position and remove it.
CAUTION
• Do not press the ENGINE
START/STOP button for more
than 10 seconds except when
the stop lamp fuse is blown.
• Do not turn the ignition switch
to the START position with the
engine running. It may dam-
age the starter.
To Next Page
Loading...
