577
Driving your vehicle
This device complies with
Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following
two conditions:
(1) This device may not cause inter-
ference, and
(2) This device must accept any
interference, including interfer-
ence that may cause undesired
operation of the device.
(Continued)
- Driving on a slope
Blind-Spot Safety system may
not operate properly when driv-
ing on a slope. The function
may not detect the vehicle in
the next lane or may incorrectly
detect the ground or structure.
Always pay attention to road
and driving conditions while
driving.
(Continued)
OSC050092
(Continued)
- Driving where the heights of
the lanes are different
Blind-Spot Safety system may
not operate properly when driv-
ing where the heights of the
lanes are different. The function
may not detect the vehicle on a
road with different lane heights
(underpass joining section,
grade separated intersections,
etc.).
Always pay attention to road
and driving conditions while
driving.
OSC050093
WARNING
• Blind-Spot Safety system may
not operate normally if inter-
fered by strong electromag-
netic waves.
• Blind-Spot Safety system may
not operate for 3 seconds
after the vehicle is started, or
the rear corner radars are ini-
tialized.
To Next Page
